|
Step 1: Cut and straighten a 4 inch piece of 18G wire. For these
earrings any wire will do. For a beginner, these earrings are easier
to make in soft wire. Step 2: Make a loop in one end of this wire. Because this loop will be cut off of the finished earrings this can be a 1/2 loop. It doesn't need to be closed. This saves a small amount of wire. |
|
| Step 3: Place one metal peg, two 3/16" Super Pegs and one 5/16" Super Peg in your jig as shown at right. |
|
| Step 4: Place the loop in your wire on the metal peg at bottom, right of the pattern and wrap the wire around the pegs as shown at right. The wire starts at bottom, right and ends at bottom left. Once this wrap is completed, remove the wire from the jig and gently squeeze it flat. |
|
