|
Step 5: Add the third metal peg and make a loop in the wire around this peg, as shown at right. |
|
| Step 6: Add the fourth metal peg and make a loop around this peg as shown at right. The angle of the V is not very important at this point, but the angle shown at right is a good approximation of what will be required. This angle will be easy to adjust later. |
 Step 6 |
| Step 7: Remove the wire from the jig and flip it over. Replace it back on the jig as shown at right. This step is important as it will allow us to make the loops on either side of the V shaped wire component to be identical. |
 Step 7 |
