|
Step 11: Remove the wire from the jig and cut the excess wire
tail off. At this point the V shaped wire component should appear as shown
at right. |
|
|
Step 12: Now we need to change the initial loop at the end of the
legs of the V into an "Eye" loop instead of a "P" loop. This is done
by grasping the wire near the loop with the tips of your round nose pliers
and bending the wire back.
For a picture of this jewelry making technique see the picture toward the
bottom of the page here. This completes the V shaped wire
component. |
 Step 12 |
|
Step 13: Now we begin making the W shaped wire component.
Position three metal pegs and two 1/4" Super Pegs in your jig as shown at
right. Now cut and straighten a 2 1/2" segment of 20 gauge jewelry
wire. |
 Step 13 |
| Step 14: Make a loop in one end of the wire segment that you just cut. |
