|
Step 15: Now remove the second 1/4" Super Peg and set it aside.
Place the loop you made in your wire over the lower right metal peg.
Wrap the wire around the first 1/4" Super Peg and around the second
(middle) metal peg as shown at right. |
|
| Step 16: Now replace the second 1/4" Super Peg and wrap the wire around this peg and the third metal peg as shown at right. |
 Step 16 |
| Step 17: Remove the wire from the jig and cut the excess wire tail. |
 Step 17 |
| Step 18: Now convert both end loops into "Eye" loops using the same technique that you used in Step 12 on the previous page. |
 Step 18 |
| Step 19: Now we need to complete the W shaped wire component. This is done by grasping the eye loops on either end (one at a time) with your bent chain nose pliers and rotating 90 degrees. When completed the two end loops will be vertical when the rest of the component is horizontal as shown at right. |
 Step 19 |
