Double Spirals Jewelry Wire & Beads Bracelet Jewelry Making Project -- Page 1

This bracelet design is made to compliment our 30 Degree Wire Spirals Earrings.   We suggest that if you make both this bracelet and the 30 Degree Wire Spiral Earrings that you make them with the same 6mm Swarovski Crystal Beads.  This bracelet is a larger and bolder bracelet than we usually make.  The picture below is very close to life size, as this bracelet is 7.5" long and about 1 1/4" wide. 

This bracelet is very strong because we have oriented the double spiral wire component on the strong axis of the piece.  If you were to grasp the double spiral wire component by the two spirals at either end and pull, you might be able to pull this wire component apart.  If, by contrast, you grasp the double spiral wire component by the sides of the piece and pull (the same orientation as shown in the bracelet below) you will find that the wire component is very strong and can't be pulled apart. 

This bracelet below was made on our WigJig Centaur, although this pattern could be modified to work on our WigJig Olympus or Olympus Lite.  This is an advanced beginner's jewelry making project. 

Skills Required:

• Ability to make a loop in wire.
• Ability to bend wire to make wire components on a jewelry making jig.
• Ability to cut with with a flush cutter.
• Ability to straighten wire with nylon jaw pliers.
• Ability to make a spiral with the WigJig Spiral Maker